Capacity is too low , EVA foam manufacturer insufficient pressure , the material EVA foam manufacturer is not normal. Dosage is generally controlled at 310 , EVA foam manufacturer magnification of 1155 to 1160 , elasticity and other mechanical properties obtained an ideal material EVA foam manufacturer .

2.4 Other additives

Stearic acid (St) is conducive to mold , but also promote the ADC's resolution , lower decomposition temperature , and promote cross-linking and EVA foam manufacturer smooth action to obtain uniform fine pore structure of closed-cell EVA foam manufacturer materials to improve EVA foam manufacturer elasticity and other mechanical properties of materials . However, it is too acidic can cause excessive consumption of the active radicals to be transferred , causing the crosslinking agent acidosis, the elastic deformation and compression are negative, the amount of 0140 parts suitable. Zinc oxide (ZnO) , and the system can be in the acid , but also can reduce the decomposition temperature of the ADC .

When the amount is too small system crosslinking agent EVA foam manufacturer much faster than the rate of decomposition , EVA foam manufacturer insufficient hardness, elasticity smaller. When the system at excessive speed crosslinking agent EVA foam manufacturer is far less than the decomposition rate , EVA foam manufacturer excessive hardness , compression set , flexibility and other mechanical properties of rapid decline .